ASN logo
Accident
Last updated: 24 October 2017
Estado:Final
Fecha:viernes 12 marzo 1999
Hora:07:30
Tipo:Silhouette image of generic B733 model; specific model in this crash may look slightly different
Boeing 737-377
Operador:Ansett Australia Airlines
Registración: VH-CZL
Numéro de série: 23664/1326
Año de Construcción: 1986-12-18 (12 years 3 months)
Motores: 2 CFMI CFM56-3B1
Tripulación:Fatalidades: 0 / Ocupantes:
Pasajeros:Fatalidades: 0 / Ocupantes:
Total:Fatalidades: 0 / Ocupantes:
Daños en la Aeronave: Considerable
Consecuencias: Repaired
Ubicación:Melbourne-Tullamarine Airport, VIC (MEL) (   Australia)
Fase: Aproximación (APR)
Naturaleza:Vuelo Doméstico Programado
Aeropuerto de Salida:Launceston Airport, TAS (LST/YMLT), Australia
Aeropuerto de Llegada:Melbourne-Tullamarine Airport, VIC (MEL/YMML), Australia
Descripción:
At the appropriate time during the approach sequence, the co-pilot of the Boeing 737, who was the handling pilot for the sector, called for the landing gear to be extended. When the pilot in command placed the landing gear lever to the "down" position, a loud thump was heard and the "gear safe" green light for the right main gear illuminated immediately. This was followed by the illumination of the left main and nose landing gear lights, consistent with a normal extension sequence. The aircraft rolled approximately 4 degrees to the right while the gear was extending. This was counteracted by a left roll control input.
As the crew had received indications that the landing gear was safely locked down, they continued the approach and completed a normal landing.
Ramp maintenance staff briefly inspected the aircraft but did not find any immediate cause for the reported thump. The aircraft was then placed on jacks for a retraction test. When the landing gear lever was selected to the "up" position, the right main landing gear moved inboard approximately 15 cm before a grinding noise was heard. The test was immediately suspended and the landing gear was extended.
When access panels were removed, it was found that the actuator beam arm inboard lugs and beam hanger had fractured. The rear wing spar, landing gear beam, aileron bus cable, pulley bracket, aileron and spoiler cables and hydraulic lines had been damaged extensively following the fracture of the lugs and hanger.
Inspection of the actuator beam arm revealed that the fracture of both lugs was due to stress corrosion cracking.

Fuentes:
» ATSB


Subsiguiente / acciones de seguridad

ATSB issued 5 Safety Recommendations

Show all AD's and Safety Recommendations

Fotos

Add your photo of this accident or aircraft

Map
This map shows the airport of departure and the intended destination of the flight. The line between the airports does not display the exact flight path.
Distance from Launceston Airport, TAS to Melbourne-Tullamarine Airport, VIC as the crow flies is 475 km (297 miles).

languages: languages

Share