ASN Wikibase Occurrence # 135284
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Saturday 19 October 2002 |
Time: | 11:50 |
Type: | RotorWay Exec 162F |
Owner/operator: | Private |
Registration: | N162AZ |
MSN: | 6398 |
Fatalities: | Fatalities: 0 / Occupants: 1 |
Aircraft damage: | Destroyed |
Category: | Accident |
Location: | Tucson, AZ -
United States of America
|
Phase: | En route |
Nature: | Private |
Departure airport: | Tucson, AZ (KRYN) |
Destination airport: | Tucson, AZ (KRYN) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:Following a drive shaft failure, the helicopter collided with high vegetation and rolled over during an autorotation. In a statement to a Federal Aviation Administration (FAA) inspector, the pilot reported that while performing pattern and ground reference maneuvers, the helicopter experienced a mechanical malfunction. The pilot executed an autorotation and contacted high vegetation with the helicopter's right skid, resulting in the helicopter rolling to the left and impacting terrain. The pilot disposed of the helicopter in a waste dump prior to examination by FAA inspectors and the nature of the mechanical malfunction could not be determined. In a telephone interview with a Safety Board investigator, the pilot reported that the secondary shaft broke in half, resulting in a loss of drive power to the helicopter's main rotor. The pilot was aware of the advisory service bulletin issued by the kit manufacturer suggesting replacement of the secondary shaft assembly, but had not complied. Beginning in May 1995, the kit manufacturer released four separate Advisory Bulletins (A-23, A-26, A-32 and A-34) addressing installation, inspection, and shaft design change issues. Citing a history of secondary shaft failures, the most recent advisory bulletin at the time of the accident, issued May 2002, recommended replacement of the standard 30 mm secondary shaft with an upgraded 35 mm shaft.
Probable Cause: the failure of the secondary drive shaft.
Sources:
NTSB:
https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20021023X05371&key=1 Location
Revision history:
Date/time | Contributor | Updates |
21-Dec-2016 19:26 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
09-Dec-2017 17:55 |
ASN Update Bot |
Updated [Operator, Other fatalities, Departure airport, Destination airport, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation