ASN Wikibase Occurrence # 153687
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Friday 4 May 2001 |
Time: | 16:16 |
Type: | Bell 407 |
Owner/operator: | Air Logistics L.L.C. |
Registration: | N917AL |
MSN: | 53381 |
Year of manufacture: | 1999 |
Total airframe hrs: | 2114 hours |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Vermillion 44, Gulf of Mexico -
United States of America
|
Phase: | En route |
Nature: | Offshore |
Departure airport: | HI-338, GM (368) |
Destination airport: | Intercoastal, LA (7RA) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:While in cruise flight, the pilot reported that a "slight vibration became noticeable." After a few minutes, the vibration became more pronounced, and was accompanied by a noise. During an attempted precautionary landing to an offshore platform, the vibration and noise level increased again, and total engine power was lost. The pilot then initiated an autorotation to the water, deployed the skid floats, and landed safely. While the helicopter was being towed in the water, the helicopter rolled inverted. Examination of the helicopter after recovery revealed that the KAflex engine-to-transmission driveshaft was fractured, and the forward tail rotor driveshaft segment was separated. Examination of the KAflex driveshaft revealed fatigue fractures that originated from a bolt hole in the first flex frame of the coupling at the transmission end of the shaft and fatigue fractures in the end fitting at the transmission end. The primary fracture was a fatigue crack that occurred in a bolt hole where a bolt joined the first flex frame to the center flex frame. The driveshaft was determined to be manufactured within engineering specifications. The fractured tail rotor driveshaft showed evidence of torsional overstress. The KAflex driveshaft coupling had a total time of 2,114.2 hours and an airworthiness life limit of 5,000 hours. Following the accident, the manufacturer issued a service bulletin introducing a new KAflex driveshaft with a 1,250-hour overhaul interval.
Probable Cause: Failure of the engine-to-transmission driveshaft coupling due to fatigue.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | FTW01FA115 |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
NTSB:
https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20010507X00892&key=1 Location
Revision history:
Date/time | Contributor | Updates |
02-Mar-2013 15:22 |
TB |
Added |
21-Dec-2016 19:28 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
10-Dec-2017 11:22 |
ASN Update Bot |
Updated [Operator, Departure airport, Destination airport, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation