ASN Wikibase Occurrence # 39335
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Saturday 31 May 1997 |
Time: | 07:05 |
Type: | RotorWay Exec 162F |
Owner/operator: | BTS Automotive |
Registration: | N176BT |
MSN: | 6144 |
Fatalities: | Fatalities: 1 / Occupants: 1 |
Aircraft damage: | Destroyed |
Category: | Accident |
Location: | Phoenix, AZ -
United States of America
|
Phase: | En route |
Nature: | Private |
Departure airport: | (DVT) |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:While inbound to an airport, the pilot transmitted 'mayday' twice, but did not state the nature of the emergency. Witnesses saw the helicopter spin 4 to 5 revolutions, then it stopped spinning & fell to the ground. Reportedly, the rotors stopped turning before ground impact. Exam of the helicopter revealed the pivot bolts & brackets for the tail rotor drive assemblies had been overtorqued, & the pivot belts had no lubrication on the bolts or associated surfaces. The tail rotor drive belt was found frayed & shredded. Both idler pulleys & their associated mountings had not been constructed or installed correctly. A tail rotor belt advisory bulletin from Rotorway advised that temperature strips be installed on the 2 tail rotor idler pulleys & the drive pulley. It required an exam of the temperature strips before & after each flight, & it cautioned that if the 170-degree dot darkened, that was an indication that a belt may be slipping or some other problem existed; & if the 180-degree dot darkened, the belts had been damaged from heat & must be replaced. Temperature dots on this helicopter indicated the temperature had exceeded 200 degrees. The owner/builder was instructed to visually check the travel of the idler pulley swing arm, condition of the drive belts, condition of the pulleys & bearings, & temperature strips during preflight inspection. Visual inspection revealed no evidence that the inspection door had ever been opened, since the original paint seal had never been broken. CAUSE: the owner/builder incorrectly installed the tail rotor drive pulley mounting scissors, overtorqued the pivot belts, did not perform the required maintenance lubrication of the pivot belts, and failed to perform adequate visual maintenance checks of these areas during the pre/postflight checks; the resultant overtemperature on the pulley idlers; eventual catastrophic failure of the drive belts; and the pilot's failure to maintain rotor rpm during autorotation, which resulted in loss of aircraft control and subsequent collision with the terrain.
Sources:
NTSB:
https://www.ntsb.gov/ntsb/brief.asp?ev_id=20001208X07963_ Revision history:
Date/time | Contributor | Updates |
24-Oct-2008 10:30 |
ASN archive |
Added |
21-Dec-2016 19:23 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation