ASN Wikibase Occurrence # 78615
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Friday 8 October 2010 |
Time: | 13:30 |
Type: | Quad City Challenger II |
Owner/operator: | Private |
Registration: | N61328 |
MSN: | CH20190W05103 |
Engine model: | Bombardier ROTAX 503 |
Fatalities: | Fatalities: 1 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Leavenworth Co near Easton, KS -
United States of America
|
Phase: | En route |
Nature: | Private |
Departure airport: | Leavenworth, KS |
Destination airport: | Leavenworth, KS |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The pilot and student-rated passenger departed the pilot’s property and remained airborne for about 10 minutes. The pilot expressed a concern about the wind and decided that they needed to return to the airfield. During the turn back to the airfield, the passenger felt like they were losing altitude and may have encountered a downdraft. The pilot told him to “hang on” and activated the airplane’s ballistic parachute. The passenger further stated that he was sure the engine was running, but he could not recall the impact sequence and he estimated the airplane was about 350 feet above ground level, when they started the turn.
Examination of the airplane revealed no evidence of preimpact anomalies and fuel was present at the accident site. The right section of the stabilizer was located about 75 feet from the main wreckage. The stabilizer section did not have any impact marks on its tube framing and the fabric appeared in good condition. The two bolts that normally hold the section on were broken. Both bolts were sent to the Safety Board Material's Laboratory for examination. The Materials Laboratory noted that both bolts had signatures consistent with a bending overload event. The separation of the stabilizer section from the airframe prior to the loss of control could not be substantiated.
Probable Cause: The pilot’s failure to maintain control of the airplane for undetermined reasons.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | CEN11LA012 |
Status: | Investigation completed |
Duration: | 8 months |
Download report: | Final report |
|
Sources:
NTSB
Location
Revision history:
Date/time | Contributor | Updates |
09-Oct-2010 23:19 |
slowkid |
Added |
12-Oct-2010 13:12 |
slowkid |
Updated [Aircraft type, Registration, Cn, Source] |
21-Dec-2016 19:25 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
26-Nov-2017 18:36 |
ASN Update Bot |
Updated [Cn, Other fatalities, Departure airport, Destination airport, Source, Narrative, Plane category] |
22-Sep-2023 10:01 |
Ron Averes |
Updated [[Cn, Other fatalities, Departure airport, Destination airport, Source, Narrative, Plane category]] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation