Accident McDonnell Douglas DC-10-10 N110AA,
ASN logo
ASN Wikibase Occurrence # 328600

Date:Friday 25 May 1979
Type:Silhouette image of generic DC10 model; specific model in this crash may look slightly different    
McDonnell Douglas DC-10-10
Owner/operator:American Airlines
Registration: N110AA
MSN: 46510/22
Year of manufacture:1972
Total airframe hrs:19871 hours
Engine model:General Electric CF6-6D
Fatalities:Fatalities: 271 / Occupants: 271
Other fatalities:2
Aircraft damage: Destroyed, written off
Location:Chicago-O'Hare International Airport, IL (ORD) -   United States of America
Phase: Take off
Nature:Passenger - Scheduled
Departure airport:Chicago-O'Hare International Airport, IL (ORD/KORD)
Destination airport:Los Angeles International Airport, CA (LAX/KLAX)
Investigating agency: NTSB
Confidence Rating: Accident investigation report completed and information captured
American Airlines Flight 191, a McDonnell-Douglas DC-10-10, crashed on takeoff from Chicago-O'Hare International Airport, Illinois, USA. The aircrtaft was destroyed and all 271 occupants were killed. Additionally, two persons on the ground sustained fatal injuries.
At 14:59 hours local time Flight 191 taxied from the gate at O'Hare Airport. The flight was bound for Los Angeles, California, with 258 passengers and 13 crewmembers on board. Maintenance personnel who monitored the flight's engine start, push-back, and start of taxi did not observe anything out of the ordinary.
The weather at the time of departure was clear, and the reported surface wind was 020° at 22 kts. Flight 191 was cleared to taxi to runway 32R for takeoff. The company's Takeoff Data Card showed that the stabilizer trim setting was 5° aircraft noseup, the takeoff flap setting was 10°, and the takeoff gross weight was 379,000 lbs. The target lowpressure compressor (N1) rpm setting was 99.4 percent, critical engine failure speed (V1) was 139 kts indicated airspeed (KIAS), rotation speed (VR) was 145 KIAS, and takeoff safety speed (V2) was 153 KIAS.
Flight 191 was cleared to taxi into position on runway 32R and hold. At 15:02:38, the flight was cleared for takeoff, and at 15:02:46 the captain acknowledged, "American one ninety-one under way." The takeoff roll was normal until just before rotation at which time sections of the No.1 (left) engine pylon structure came off the aircraft. Witnesses saw white smoke or vapor coming from the vicinity of the No. 1 engine pylon. During rotation the entire No. 1 engine and pylon separated from the aircraft, went over the top of the wing, and fell to the runway.
Flight 191 lifted off about 6,000 ft down runway 32R, climbed out in a wings-level attitude.
About nine seconds after liftoff, the airplane had accelerated to 172 knots and reached 140 feet of altitude. As the climb continued, the airplane began to decelerate at a rate of about one knot per second, and at 20 seconds after liftoff, and an altitude of 325 feet, airspeed had been reduced to 159 knots. At this point, the airplane began to roll to the left, countered by rudder and aileron inputs. The airplane continued to roll until impact, 31 seconds after liftoff, and in a 112-degree left roll, and 21-degree nose down pitch attitude.
At 15:04 Flight 191 crashed in an open field and trailer park about 4,600 ft northwest of the departure end of runway 32R. The aircraft was demolished during the impact, explosion, and ground fire.

The No.1 engine pylon failure during takeoff was determined to have been caused by unintended structural damage which occurred during engine/pylon reinstallation using a forklift. The engine/pylon removal and reinstallation were being conducted to implement two DC-10 Service Bulletins. Both required that the pylons be removed, and recommended that this be accomplished with the engines removed. The Service Bulletin instructions assumed that engines and pylons would be removed separately, and did not provide instructions to remove the engine and pylon as a unit. Additionally, removal of the engines and pylons as a unit was not an approved Maintenance Manual procedure.
The lack of precision associated with the use of the forklift, essentially an inability to perform the fine manipulations necessary to accomplish reinstallation of the engine/strut assembly, in combination with the tight clearances between the pylon flange and the wing clevis resulted in damage to the same part that had just been inspected.
Inspections of other DC-10 pylon mounts following the accident resulted in nine additional cracked mounts being identified.

PROBABLE CAUSE: "The asymmetrical stall and the ensuing roll of the aircraft because of the uncommanded retraction of the left wing outboard leading edge slats and the loss of stall warning and slat disagreement indication systems resulting from maintenance-induced damage leading to the separation of the no.1 engine and pylon assembly procedures which led to failure of the pylon structure.
Contributing to the cause of the accident were the vulnerability of the design of the pylon attach points to maintenance damage; the vulnerability of the design of the leading edge slat system to the damage which produced asymmetry; deficiencies in FAA surveillance and reporting systems which failed to detect and prevent the use of improper maintenance procedures; deficiencies in the practices and communications among the operators, the manufacturer, and the FAA which failed to determine and disseminate the particulars regarding previous maintenance damage incidents; and the intolerance of prescribed operational procedures to this unique emergency."

Accident investigation:
Investigating agency: NTSB
Report number: DCA79AA017
Status: Investigation completed
Duration: 7 months
Download report: Final report


NTSB Safety Recommendations A-79-98/105



photo (c) NTSB; Chicago-O'Hare International Airport, IL (ORD/KORD); May 1979; (publicdomain)

photo (c) Werner Fischdick; Los Angeles International Airport, CA (LAX); 18 August 1973

photo (c) Bob Garrard; Toronto-Pearson International Airport, ON (YYZ/CYYZ); July 1977

Revision history:


The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF on social media FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2024 Flight Safety Foundation

1920 Ballenger Av, 4th Fl.
Alexandria, Virginia 22314