ASN logo
Last updated: 29 July 2021
Status:Schlussbericht
Datum:Freitag 21 September 1990
Zeit:09:25
Flugzeugtyp:Silhouette image of generic B703 model; specific model in this crash may look slightly different
Boeing 707-336C
Fluggesellschaft:Air Hong Kong
Kennzeichen: VR-HKK
Werknummer: 20517/854
Baujahr: 1971-05-18 (19 years 4 months)
Besatzung:Todesopfer: 0 / Insassen: 3
Fluggäste:Todesopfer: 0 / Insassen: 2
Gesamt:Todesopfer: 0 / Insassen: 5
Sachschaden: schwer beschädigt
Konsequenzen: Repaired
Unfallort:Sydney-Kingsford Smith International Airport, NSW (SYD) (   Australien)
Flugphase: Rückstellung/Schleppen (PBT)
Betriebsart:Frachtflug
Flug von:Sydney-Kingsford Smith International Airport, NSW (SYD/YSSY), Australien
Flug nach:?
Unfallbericht:
The Boeing 707 cargo aircraft was being prepared for a normal push-back from the freight apron position V2 at Sydney-Kingsford Smith Airport, Australia.
A towing tug was connected to the nose gear and number two engine was running at idle power. The aircraft was cleared to be pushed back to taxiway G where the other engines would be started. The aircraft brakes were released but as the tug took the weight for the push back, there was a loud report and the nose of the aircraft collapsed onto the cabin roof of the tug. The nose wheels folded back under the fuselage and arrested its fall, saving the tug cabin from further collapse. The engine was immediately shut down and the crew departed the aircraft to assess the damage. Investigation revealed the nose landing gear oleo outer cylinder
had failed at the upper end of the cylinder bore. The failure was initiated by a fatigue crack in the radius at the bore end forward quadrant. The radius in the vicinity of the crack was found to be .039 inches, marginally less than the manufacturer's minimum dimension of .040 inches. Extension of the crack due to stress corrosion was extremely rapid and may have occurred whilst the aircraft was parked at Sydney.

Probable Cause:

Significant Factors:
The following factors were considered relevant to the development of the accident
1. A fatigue crack developed in the bore top radius of the nose landing gear cylinder.
2. The marginal dimension of the bore top radius may have contributed to the development of the initial fatigue crack.
3. Stress corrosion then developed the crack at a rapid rate to final failure.

Accident investigation:
cover
Investigating agency: BASI
Status: Investigation completed
Duration: 1 year and 4 months
Accident number: 199002004
Download report: Summary report


Sicherheitsempfehlungen
Because of numerous reports of cracking in this area, the manufacturer issued a service letter recommending that operators consider replacement of nose landing gear cylinders fabricated from 7079-T6 alloy with cylinders of 7075-T3 or 7049-T73 alloy at overhaul.

Fotos

Add your photo of this accident or aircraft
This information is not presented as the Flight Safety Foundation or the Aviation Safety Network’s opinion as to the cause of the accident. It is preliminary and is based on the facts as they are known at this time.
languages: languages

Share