Beschrijving:
On final approach approximately 10 miles from the airport, the flight crew received an aft cargo bay fire warning. The flight crew followed checklist procedures, activated the cargo bay fire extinguishers and declared an emergency. The fire indication went out some 20 to 30 seconds after activation of the fire
extinguishers, but a slight smell of smoke was noticed by the cabin crew and flight crew. Flight 116 landed and stopped on the runway to allow airport
firefighters to inspect the aircraft for fire. Firefighters, using infrared sensing equipment, did not detect any sign of fire. The flight crew taxied the aircraft to the terminal but stopped approximately 40 feet back from the gate to allow firefighters to open the aft cargo compartment for a detailed inspection. When the cargo door was opened, a significant amount of smoke was observed. Firefighters entered the cargo compartment and confirmed that the fire had been extinguished. TSB investigators discovered that an intense but relatively small fire had occurred, causing significant structural damage in the floor area of the aft
cargo compartment. Before it was extinguished, the fire had progressed approximately 18 inches up the right side wall of the aircraft, outside the aft cargo compartment. The cargo bay fire-extinguishing system, a Halon-based system, effectively suppressed the fire before it could spread further. The fire appears to have been a direct result of an electrical failure of a heater tape used to prevent water lines from freezing. The electrical failure of the heater tape ignited the covering of the insulation blankets installed below the open cargo floor and some debris found in the area.
FINDINGS AS TO CAUSES AND CONTRIBUTING FACTORS: "1. The B110 heater ribbon attached to the water supply line failed at the site of a recent water line repair, which allowed the elements of the heater ribbon to electrically arc, providing a source of ignition to surrounding materials; 2. The polyethylene terephthalate (PET) covering material of the thermal acoustic insulation was contaminated. The contaminated material provided an ignitable source of fuel for a self-sustaining fire; 3. The open cargo floor provided a trap that collected contaminants and debris in the bilge area of the cargo compartment; the debris and contaminants were an ignitable source of fuel to sustain a fire; 4. Circuit protection devices are designed to protect aircraft wiring and not aircraft components. The lack of circuit protection of the heater ribbon system permitted the heater ribbon failure to result in an arcing event."
| Status: | Accident investigation report completed and information captured |
| Datum: | maandag 13 mei 2002 |
| Tijd: | 17:37 EDT |
| Type: |  Boeing 767-3Y0ER |
| Luchtvaartmaatschappij: | Air Canada |
| Registratie: | C-GHML |
| Constructienummer: | 24948/380 |
| Bouwjaar: | 1991-07-02 (10 years 11 months) |
| Aantal vlieguren: | 46830 |
| Motoren: | 2 Pratt & Whitney PW4060 |
| Bemanning: | slachtoffers: 0 / inzittenden: 8 |
| Passagiers: | slachtoffers: 0 / inzittenden: 177 |
| Totaal: | slachtoffers: 0 / inzittenden: 185 |
| Schade: | Groot |
| Gevolgen: | Repaired |
| Plaats: | Toronto-Pearson International Airport, ON (YYZ) ( Canada)
|
| Fase: | Nadering (APR) |
| Soort vlucht: | Binnenlandse lijnvlucht |
| Vliegveld van vertrek: | Vancouver International Airport, BC (YVR/CYVR), Canada |
| Toronto-Pearson International Airport, ON (YYZ/CYYZ), Canada | |
| Vluchtnummer: | 116 |
On final approach approximately 10 miles from the airport, the flight crew received an aft cargo bay fire warning. The flight crew followed checklist procedures, activated the cargo bay fire extinguishers and declared an emergency. The fire indication went out some 20 to 30 seconds after activation of the fire
extinguishers, but a slight smell of smoke was noticed by the cabin crew and flight crew. Flight 116 landed and stopped on the runway to allow airport
firefighters to inspect the aircraft for fire. Firefighters, using infrared sensing equipment, did not detect any sign of fire. The flight crew taxied the aircraft to the terminal but stopped approximately 40 feet back from the gate to allow firefighters to open the aft cargo compartment for a detailed inspection. When the cargo door was opened, a significant amount of smoke was observed. Firefighters entered the cargo compartment and confirmed that the fire had been extinguished. TSB investigators discovered that an intense but relatively small fire had occurred, causing significant structural damage in the floor area of the aft
cargo compartment. Before it was extinguished, the fire had progressed approximately 18 inches up the right side wall of the aircraft, outside the aft cargo compartment. The cargo bay fire-extinguishing system, a Halon-based system, effectively suppressed the fire before it could spread further. The fire appears to have been a direct result of an electrical failure of a heater tape used to prevent water lines from freezing. The electrical failure of the heater tape ignited the covering of the insulation blankets installed below the open cargo floor and some debris found in the area.
Probable Cause:
FINDINGS AS TO CAUSES AND CONTRIBUTING FACTORS: "1. The B110 heater ribbon attached to the water supply line failed at the site of a recent water line repair, which allowed the elements of the heater ribbon to electrically arc, providing a source of ignition to surrounding materials; 2. The polyethylene terephthalate (PET) covering material of the thermal acoustic insulation was contaminated. The contaminated material provided an ignitable source of fuel for a self-sustaining fire; 3. The open cargo floor provided a trap that collected contaminants and debris in the bilge area of the cargo compartment; the debris and contaminants were an ignitable source of fuel to sustain a fire; 4. Circuit protection devices are designed to protect aircraft wiring and not aircraft components. The lack of circuit protection of the heater ribbon system permitted the heater ribbon failure to result in an arcing event."
Accident investigation:
 |
|
Bronnen:
» TSBVeiligheidsmaatregelen
During the inspection of this and other aircraft, additional examples of overheated and burned heater tapes were discovered. Affected systems were deactivated.
On June 7, 2002 the FAA issued Airworthiness Directive AD 2002-11-11 applicable to certain Boeing Model 767-200, -300, and -300F series airplanes. This action requires an inspection of visually accessible areas for indications of overheating of the heater tape attached to the potable water fill and drain lines in the forward and aft cargo compartments, exposed foam insulation or missing or damaged protective tape around the potable water fill and drain lines, and debris or contaminants on or near the potable water fill and drain lines. It also requires corrective action, as necessary. This action is necessary to prevent overheating of the heater tape on potable water fill and drain lines, which may ignite accumulated debris or contaminants on or near the potable water fill and drain lines, resulting in a fire in the airplane. This action is intended to address the identified unsafe condition. TSB issued 2 Safety Recommendations
Show all...
On June 7, 2002 the FAA issued Airworthiness Directive AD 2002-11-11 applicable to certain Boeing Model 767-200, -300, and -300F series airplanes. This action requires an inspection of visually accessible areas for indications of overheating of the heater tape attached to the potable water fill and drain lines in the forward and aft cargo compartments, exposed foam insulation or missing or damaged protective tape around the potable water fill and drain lines, and debris or contaminants on or near the potable water fill and drain lines. It also requires corrective action, as necessary. This action is necessary to prevent overheating of the heater tape on potable water fill and drain lines, which may ignite accumulated debris or contaminants on or near the potable water fill and drain lines, resulting in a fire in the airplane. This action is intended to address the identified unsafe condition. TSB issued 2 Safety Recommendations
Show all...
Foto's
Kaart
Deze kaart geeft het vliegveld van vetrek weer en de geplande bestemming van de vlucht. De lijn tussen de vliegvelden geeft niet de exacte vliegroute weer.
De afstand tussen Vancouver International Airport, BC en Toronto-Pearson International Airport, ON bedraagt 3321 km (2076 miles).
Accident location: Approximate; accuracy within a few kilometers.
De afstand tussen Vancouver International Airport, BC en Toronto-Pearson International Airport, ON bedraagt 3321 km (2076 miles).
Accident location: Approximate; accuracy within a few kilometers.
This information is not presented as the Flight Safety Foundation or the Aviation Safety Network’s opinion as to the cause of the accident. It is preliminary and is based on the facts as they are known at this time.
The Aviation Safety Network is an exclusive service provided by:
Quick Links:
| ASN Home | Send Correction / Feedback |
| FSF Home | Disclaimer | Copyright |
| Contact Us | Privacy Policy |
| Press / Media |
CONNECT WITH US:
©2023 Flight Safety Foundation