ASN logo
Last updated: 21 October 2019
Statuts:Enquête Officielle
Date:samedi 14 octobre 2017
Heure:19:32
Type/Sous-type:Silhouette image of generic B738 model; specific model in this crash may look slightly different
Boeing 737-838 (WL)
Compagnie:Qantas
Immatriculation: VH-VZZ
Numéro de série: 39445/4010
Année de Fabrication: 2012-04-14 (5 years 6 months)
Moteurs: 2 CFMI CFM56-7B26E
Equipage:victimes: 0 / à bord: 7
Passagers:victimes: 0 / à bord: 174
Total:victimes: 0 / à bord: 181
Dégats de l'appareil: Mineurs
Conséquences: Repaired
Lieu de l'accident:Sydney-Kingsford Smith International Airport, NSW (SYD) (   Australie)
Phase de vol: Tracté (PBT)
Nature:Transport de Passagers Nat.
Aéroport de départ:Sydney-Kingsford Smith International Airport, NSW (SYD/YSSY), Australie
Aéroport de destination:Melbourne-Tullamarine Airport, VIC (MEL/YMML), Australie
Détails:
At about 18:30 local time on 14 October 2017, the flight crew of a Qantas Boeing 737 boarded the aircraft at Sydney Airport, Australia. The aircraft was scheduled to operate a passenger flight to Melbourne, Victoria, with two flight crew, five cabin crew, and 174 passengers.
After boarding, the flight crew found the aircraft had no battery power, as the battery switch had inadvertently been left on. Consequently, another Boeing 737 aircraft, registered VH-VZZ (VZZ) was assigned for the flight. Catering had already been loaded on the originally assigned aircraft so a catering crew (driver and marshaller) were tasked to transfer the catering to VZZ.
At about 19:10, a dispatch engineer was assigned to the departure of VZZ, which was scheduled for 19:30.
At about 19:21, the engineer arrived at the aircraft, and received a handover from the other engineer who had been in attendance. The engineers discussed the aircraft status under the aerobridge as it had just started to rain. At this time, the catering vehicle (truck) was loading the forward galley through the right forward main entry door. The pushback vehicle's (tug) towbar was already connected to the aircraft.
At about 19:22, the catering crew completed loading the forward galley. They then moved the truck to the right rear main entry door and began loading the rear galley.
The engineer completed his walk around of VZZ and stood under the wing waiting for the catering crew to complete loading. He saw the catering crew close the main entry door and then visually checked that the aircraft door was closed.
The engineer then proceeded towards the front of the aircraft. He put on his headset, which was connected to an external jack point, and contacted the flight crew who confirmed they were ready to depart. As it was still raining, the engineer entered the right side of the tug and sat in its cabin. Meanwhile, the catering crew retracted the truck's loading platform and began lowering the truck's body.
At about 19:30, air traffic control cleared VZZ for pushback, and its captain informed the engineer accordingly. When the aerobridge had been retracted, the engineer leaned out of the tug cabin and completed a visual check of the left forward main entry door.
At 19:32:23, the catering truck body had finished lowering and the stabilisers began to raise. The crew exited the truck body. A few seconds later, the flight crew turned on the aircraft's anti-collision light.
At 19:32:43, the engineer looked left and right from the tug cabin to check for vehicles. He then gave the 'thumbs up' signal to the tug driver to commence pushback. When VZZ began reversing, the engineer approved the flight crew to start the right engine. The crew selected the engine start switch and the engine began rotating. The catering truck driver began reversing the truck at this time.
A few seconds later, the catering truck's marshaller identified that VZZ was moving and tried to alert the truck driver. At the same time, the engineer saw that the catering truck was not clear and 'yelled' at the tug driver to stop. The tug driver immediately applied the brakes. The tug stopped but the pins in the towbar sheared and it separated from VZZ.
The flight crew heard a loud 'bang' and then saw VZZ moving away from the tug. The catering truck was reversing but still 5-7 m behind the aircraft's right engine so the engineer asked the flight crew to apply the aircraft's brakes. The captain applied the brakes as firmly as possible. The aircraft slowed but continued rolling back 3-4 m.
At 19:32:53, the aircraft's right wing collided with the truck before it came to a stop. The flight crew then engaged the aircraft's park brake and turned the right engine switch to OFF and the engine wound down as fuel had not been introduced.
The aircraft was found to have substantial damage to its right outboard flaps, wing structure between the flaps and aileron, and the aileron.

Probable Cause:

Findings:
- The dispatch engineer assumed that the catering truck was clear and did not visually confirm it was before he cleared VH-VZZ for pushback. In part, this assumption was based on an incorrect expectation of the time required for the truck to move clear.
- The engineer’s view of the truck from the pushback tug’s cabin was largely obstructed by the aircraft. The dark and rainy conditions also made it difficult to see the truck, and the engineer saw it too late to prevent the collision.

Accident investigation:
cover
Investigating agency: ATSB
Status: Investigation completed
Duration: 1 year and 1 months
Accident number: AO-2017-099
Download report: Final report


Photos

Add your photo of this accident or aircraft

Plan
Ce plan montre l'aéroport de départ ainsi que la supposée destination du vol. La ligne fixe reliant les deux aéroports n'est pas le plan de vol exact.
La distance entre Sydney-Kingsford Smith International Airport, NSW et Melbourne-Tullamarine Airport, VIC est de 703 km (440 miles).

Les informations ci-dessus ne représentent pas l'opinion de la 'Flight Safety Foundation' ou de 'Aviation Safety Network' sur les causes de l'accident. Ces informations prélimimaires sont basées sur les faits tel qu'ils sont connus à ce jour.
languages: languages

Share