Flugunfall 19 NOV 2017 einer ATR 72-212A (ATR 72-600) VH-FVZ - Canberra Airport, ACT (CBR)
ASN logo
 

Status:Accident investigation report completed and information captured
Datum:Sonntag 19 November 2017
Zeit:0.41652894020081
Flugzeugtyp:Silhouette image of generic AT76 model; specific model in this crash may look slightly different
ATR 72-212A (ATR 72-600)
Fluggesellschaft:Virgin Australia Airlines
Kennzeichen: VH-FVZ
Werknummer: 1087
Baujahr: 2013-04-25 (4 years 7 months)
Triebwerk: 2 Pratt & Whitney Canada PW127M
Besatzung:Todesopfer: 0 / Insassen: 5
Fluggäste:Todesopfer: 0 / Insassen: 67
Gesamt:Todesopfer: 0 / Insassen: 72
Sachschaden: schwer beschädigt
Konsequenzen: Repaired
Unfallort:Canberra Airport, ACT (CBR) (   Australien)
Flugphase: Landung (LDG)
Betriebsart:Inländischer planmäßiger Passagierflug
Flug von:Sydney-Kingsford Smith International Airport, NSW (SYD/YSSY), Australien
Flug nach:Canberra Airport, ACT (CBR/YSCB), Australien
Flugnummer:VA646
Unfallbericht:
A Virgin Australia Airlines ATR 72-600 suffered a hard landing accident at Canberra Airport, Australia.
The aircraft was being operated by Virgin Australia as flight 646 on a scheduled passenger flight from Sydney to Canberra. On board the aircraft was the captain, first officer, a check captain, two cabin crew and 67 passengers.
The first officer was pilot flying, and the captain was pilot monitoring. The check captain was positioned in the observer seat on the flight deck and was conducting an annual line check of the captain along with a six month line check of the first officer over four flights on the day. The occurrence flight was the last of these flights.
At about 13:20 local time the flight crew were conducting a visual approach to runway 35 at Canberra. The calculated approach speed was 113 kt. At 13:20:52, nine seconds prior to touch down, the aircraft approached the runway at a height of about 107 ft, slightly above the desired approach path. The flight crew reported that at about this time, there was turbulence and changing wind conditions. Flight data showed that at this time, speed had increased to 127 kt. In response to the increasing speed, the first officer reduced power to near flight idle.
Over the next five seconds, the descent rate increased significantly and the speed reduced.
During the last 50 ft of descent, the captain twice called for an increase in power and then called for a go-around. The first officer responded by increasing the power at about the same time as the aircraft touched down.
At 13:21:01, the aircraft touched down heavily on the main landing gear and rear fuselage with a peak recorded vertical acceleration of 2.97G. Assessing that the aircraft was under control, the captain immediately called to the first officer to cancel the go-around and then took control of the aircraft. The flight crew completed the landing roll and taxied to the gate without further incident.
After shutting down the engines, the flight crew reviewed the recorded landing data which indicated a hard landing had occurred, requiring maintenance inspections. The captain then made an entry in the aircraft technical log, and subsequent inspections revealed that the aircraft had been substantially damaged. There were no reported injuries.

Probable Cause:

Contributing factors:
- During the approach, the pilot flying did not identify that the speed had exceeded the stabilised approach criteria, which required immediate correction or initiation of a go-around.
- In response to an assessment of overshoot shear, the pilot flying reduced power to idle at a height greater than that stipulated by operator procedures. This resulted in an abnormally high descent rate that was not reduced prior to touchdown.
- A significant change in the wind direction and strength immediately before the aircraft touched down further increased the aircraft's descent rate and contributed to the resultant damage.
- Verbal and physical intervention by the pilot monitoring did not prevent the hard landing.

Accident investigation:
cover
Investigating agency: ATSB
Status: Investigation completed
Duration: 2 years
Accident number: AO-2017-111
Download report: Final report

Informationsquelle:
» ATSB

METAR Weather report:
02:00 UTC / 13:00 local time:
YSCB 190200Z 10013KT 9999 SCT050 SCT240 21/08 Q1024 NOSIG

03:00 UTC / 14:00 local time:
YSCB 190300Z 06010KT 040V110 9999 SCT052 SCT250 22/09 Q1023 NOSIG


Fotos

photo of ATR-72-600-VH-FVZ
accident date: 19-11-2017
type: ATR 72-600
registration: VH-FVZ
photo of ATR-72-600-VH-FVZ
relevant recorded parameters captured by the FDR
 

Map
This map shows the airport of departure and the intended destination of the flight. The line is connecting ADS-B datapoints from Flightradar24.
Distance from Sydney-Kingsford Smith International Airport, NSW to Canberra Airport, ACT as the crow flies is 236 km (147 miles).
Accident location: Approximate; accuracy within a few kilometers.

This information is not presented as the Flight Safety Foundation or the Aviation Safety Network’s opinion as to the cause of the accident. It is preliminary and is based on the facts as they are known at this time.
languages: languages

Share

The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2023 Flight Safety Foundation

1920 Ballenger Av., 4th Fl.
Alexandria, Virginia 22314
www.FlightSafety.org