ASN Wikibase Occurrence # 205437
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Monday 27 February 1989 |
Time: | 19:53 |
Type: | Piper PA-34-200 |
Owner/operator: | |
Registration: | VH-CJI |
MSN: | 34-7250099 |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Location: | Bankstown Airport (YSBK), Bankstown, NSW -
Australia
|
Phase: | Landing |
Nature: | Private |
Departure airport: | YSBK |
Destination airport: | YPPF |
Investigating agency: | BASI |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The pilot had selected the landing gear up after takeoff. During climb, at about 1600 feet, he noticed that the red gear unsafe light was still illuminated, and by checking the nacelle mirror, that the nose gear was still extended. The wheel also appeared to be turned at an angle. The pilot returned to Bankstown, where it was observed that the nose wheel was turned through about 80 degrees to the right. Use of full rudder control and cycling of the landing gear failed to produce any change in the position of the nose gear. After seeking engineering advice, the pilot elected to land on grass and an area was prepared on the left of, and parallel to the runway. He advised that he intended to shut down the engines on short final approach and position the propellers to preclude ground contact on landing. At about 200 feet on final approach he shut down the engines but had insufficient time to reposition the propellers. The aircraft dropped with a high sink rate and touched down 110 metres short of the intended landing area. On initial ground contact, the left main gear pushed up through the wing and broke off. The aircraft slewed to the left and the nose gear broke off during the 85 metre slide. It was found that the right hand nose wheel steering stop had been sheared, probably during ground handling operations. This resulted in detachment of the tiller roller from the steering channel and bending of the torque link pivot bolt. The torque link subsequently failed across the pivot bolt hole, allowing the nose leg to turn approximately 80 degrees.
Accident investigation:
|
| |
Investigating agency: | BASI |
Report number: | |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
https://www.atsb.gov.au/publications/investigation_reports/1989/aair/aair198902545/ https://www.atsb.gov.au/media/33839/aair198902545.pdf Revision history:
Date/time | Contributor | Updates |
31-Jan-2018 16:14 |
Pineapple |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation