ASN Wikibase Occurrence # 160243
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Friday 6 September 2013 |
Time: | 17:54 |
Type: | ERCO 415-D Ercoupe |
Owner/operator: | Private |
Registration: | N3940H |
MSN: | 4641 |
Year of manufacture: | 1947 |
Total airframe hrs: | 2219 hours |
Engine model: | Continental A&C75 SERIES |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Near Beaver County Airport (KBVI), Beaver Falls, PA -
United States of America
|
Phase: | Landing |
Nature: | Private |
Departure airport: | Beaver Falls, PA (BVI) |
Destination airport: | Clarksburg, WV (CKB) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:According to the pilot, he departed for a flight to his home base airport, and, while the airplane was climbing through 200 ft above ground level, the engine began to run roughly. While he was attempting to turn back toward the airport, the engine experienced a total loss of power, and he subsequently made an emergency landing in a nearby field. No anomalies were noted with the carburetor or the induction, ignition, and fuel systems; 100 low lead fuel was found in the header tank.
A postaccident examination of the engine revealed that the No. 3 cylinder exhaust valve was stuck in the “open” position and that the Nos. 2 and 4 cylinder spark plugs were carbon fouled. Although an engine manufacturer service bulletin (SB) stated that 100 low lead fuel was an acceptable alternative fuel, it also indicated that “the amount of tetraethyl lead in these higher grade fuels has increased the lead build up and fouling of spark plugs.” The SB noted that, when this type of fuel is used, “exhaust valve sticking could result from lead salt accumulation in the lubricating oil,” and it recommended that “regular 50 hour oil changes be implemented to reduce such accumulation.” The SB also recommended that the spark plugs be rotated every 50 hours of operation and cleaned and rotated every 100 hours. A review of the engine maintenance logbooks revealed that the airplane’s most recent annual inspection was completed about 60 hours before the accident. No record was found indicating that the oil was changed after the annual inspection. Based on the condition of the exhaust valve and the spark plugs and the maintenance records, it is likely that the pilot did not follow the SB-recommended procedures, which resulted in the engine carbon buildup and the exhaust valve being stuck open.
Probable Cause: The owner/pilot’s failure to follow engine manufacturer recommendations for engine oil changes and spark plug cleaning and rotating when operating the airplane with 100 low lead fuel, which resulted in carbon buildup in the engine and the total loss of engine power due to the No. 3 cylinder exhaust valve being stuck open.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | ERA13LA406 |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
NTSB
Location
Revision history:
Date/time | Contributor | Updates |
07-Sep-2013 16:31 |
Geno |
Added |
09-Sep-2013 18:07 |
harro |
Updated [Aircraft type, Registration, Cn, Operator, Source] |
21-Dec-2016 19:28 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
29-Nov-2017 09:14 |
ASN Update Bot |
Updated [Operator, Other fatalities, Nature, Departure airport, Destination airport, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation