ASN Wikibase Occurrence # 179108
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Sunday 27 June 2004 |
Time: | 07:30 |
Type: | Beech V35B |
Owner/operator: | Private |
Registration: | N2167L |
MSN: | D-9932 |
Total airframe hrs: | 3566 hours |
Fatalities: | Fatalities: 0 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Stennis International Airport, Bay Saint Louis, Mississippi -
United States of America
|
Phase: | Landing |
Nature: | Private |
Departure airport: | Mobile, AL (KBFM) |
Destination airport: | Bay Saint Louis, MS (KHSA) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The pilot stated that the flight proceeded to the destination airport where he descended to traffic pattern altitude and entered the downwind leg at a normal 45-degree entry. When abeam the numbers during the downwind leg, he placed the landing gear selector handle to the down position and observed three green lights. He also reported that the airplane slowed as though the extended gear drag was present. The rest of the approach was what he considered typical and at no time was there any indication that something was "amiss." After a typical final approach he reduced power to idle and entered ground effect, then during the flare approximately 2-5 feet above the runway surface, he heard the gear warning horn sound but it was not until the propeller contacted the runway surface did he realize, "...the gear must not have been locked, or must have cycled back into the up position." The airplane came to rest on the right side of the runway. The pilot further stated that after the airplane was raised from the runway, all landing gears were in their respective wheel wells with the doors fully closed. He then entered the cockpit, noted the landing gear motor circuit breaker was popped, and cycled the landing gear selector handle from the down to the up then down position. He then pushed in the landing gear motor circuit breaker, turned on the master switch, and the landing gear extended. The airplane was then towed to the hangar. Following recovery of the airplane the airplane, it was placed on jacks and in the presence of an FAA airworthiness inspector, six complete landing gear retraction checks were performed with no discrepancies noted.
Probable Cause: The failure of the pilot to verify the landing gear was extended prior to touchdown resulting in a gear-up landing.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | MIA04LA102 |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
NTSB:
https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20040709X00935&key=1 Location
Revision history:
Date/time | Contributor | Updates |
29-Aug-2015 17:07 |
Noro |
Added |
21-Dec-2016 19:30 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
07-Dec-2017 18:05 |
ASN Update Bot |
Updated [Other fatalities, Departure airport, Destination airport, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation