ASN Wikibase Occurrence # 42403
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Sunday 4 October 1998 |
Time: | 15:15 |
Type: | Revolution Mini-500 |
Owner/operator: | William Mark Burson |
Registration: | N418MB |
MSN: | 0279 |
Total airframe hrs: | 33 hours |
Fatalities: | Fatalities: 1 / Occupants: 1 |
Aircraft damage: | Destroyed |
Category: | Accident |
Location: | Moorpark, CA -
United States of America
|
Phase: | Manoeuvring (airshow, firefighting, ag.ops.) |
Nature: | Private |
Departure airport: | |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The helicopter did not return from an afternoon local area flight and the wreckage was located early the following morning. Both main rotor blades, the tail rotor assembly, the tail boom, and a section of the tail rotor drive shaft were found in a debris field approximately 1/8 mile from the fuselage wreckage. Both main rotor blades separated from the hub outboard of the root doubler and exhibited leading edge damage near the tip and downward bending. Additionally, the 'A' blade was bent smoothly aft approximately 30 degrees over its span. The tail boom was separated from the fuselage approximately 2 feet forward of the tail rotor gearbox. The separation exhibited a diagonal slicing appearance from upper forward to lower aft on the boom. The tail rotor drive shaft was separated at the same fuselage station as the tail boom, and the shaft had a dented appearance which resembled the leading edge radius of the main rotor blade. The main rotor mast exhibited a mast-bumping dent on one side of the mast at the hub attachment but no similar dent on the opposite side. Examination of the aircraft did not reveal any mechanical malfunction of the engine or flight control system.
CAUSE: The improper use of the cyclic flight control by the pilot, which resulted in low g flight load condition, which resulted in rotor disk divergence (mast bumping), and the main rotor blade striking and severing the tail boom.
Sources:
NTSB:
http://www.ntsb.gov/ntsb/brief.asp?ev_id=20001211X11285 Revision history:
Date/time | Contributor | Updates |
24-Oct-2008 10:30 |
ASN archive |
Added |
21-Dec-2016 19:24 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation