Accident McDonnell Douglas MD 600N N611BC,
ASN logo
ASN Wikibase Occurrence # 43263
 
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information. If you feel this information is incomplete or incorrect, you can submit corrected information.

Date:Friday 3 March 2000
Time:15:29
Type:Silhouette image of generic MD60 model; specific model in this crash may look slightly different    
McDonnell Douglas MD 600N
Owner/operator:GECC opb WTVJ NBV 6
Registration: N611BC
MSN: RN008
Year of manufacture:1997
Total airframe hrs:964 hours
Engine model:Allison 250-C47M
Fatalities:Fatalities: 2 / Occupants: 2
Aircraft damage: Destroyed
Category:Accident
Location:Miami, FL -   United States of America
Phase: Manoeuvring (airshow, firefighting, ag.ops.)
Nature:Survey
Departure airport:Kendall-Tamiami Executive Airport, FL (KTMB)
Destination airport:Kendall-Tamiami Executive Airport, FL (KTMB)
Investigating agency: NTSB
Confidence Rating: Accident investigation report completed and information captured
Narrative:
On March 3, 2000, at about 1529 eastern standard time, a McDonnell Douglas HU-600N, N611BC, registered to General Electric Capital Corporation, operated by WTVJ NBC 6, as a 14 CFR Part 91 photography flight, crashed in a residential area while maneuvering in the vicinity of Miami, Florida. Visual meteorological conditions prevailed and no flight plan was filed. The helicopter was destroyed by a post crash fire. The airline transport pilot and news photographer were fatally injured. The flight originated from Kendall-Tamiami Executive Airport (TMB), Miami, Florida, about 26 minutes before the accident.

The Sky 6 pilot was returning to Tamiami Airport, Miami, Florida, when he overheard a friend departing the airport. They established radio contact on the air-to-air frequency, and the sky 6 pilot decided to join his friend on the outbound leg. He made a 180 degree turn, and joined up on the right side of his friends helicopter. They talked for a short time and the Sky 6 pilot departed. His friend stated, Sky 6 started a descent estimated at about 15 degree nose-down attitude. His passenger stated Sky 6 descent was about a 45 degree nose down attitude. The friend and the passenger stated the nose of Sky 6 pitched up 70 degrees or past the 90 degree point. The helicopter yawed to the left, held there, appeared to slide backwards, the nose pitched down, the tail boom assembly separated, and the helicopter collided with terrain. Another news helicopter pilot, who knew the Sky 6 pilot, stated he overheard Sky 6 talking with another pilot on the air-to-air frequency. Based on there conversation he assumed they knew each other. At about 1530, he and a flight controller heard Sky 6 state, 'watch this.' There was no other communication between Sky 6 and the other pilot. Witnesses on the ground stated they observed both helicopters in straight and level flight. The accident helicopter nose was observed to pitch down and then pitched up to a near vertical nose-up attitude. The helicopter yawed to the left, slid backwards, the nose pitched down, and the tail boom separated. The helicopter started rotating to the right until it disappeared from view. Other news helicopter pilots stated the Sky 6 pilot would arrive at a news scene and stop the helicopter by conducting a cyclic climb maneuver and then bring the helicopter to a hover. A friend of the Sky 6 pilot stated he had a conversation with the pilot during the first part of February 2000. The pilot described a maneuver that he had been performing in the helicopter. He would make a high speed pass down a runway followed by a steep pull-up. At the top of the pull-up he would reverse the heading by 180 degrees, and then recover from the ensuing dive similar to a hammerhead turn in a fixed wing aircraft. Examination of the airframe, flight controls, engine assembly and accessories revealed no evidence of a precrash mechanical failure or malfunction. Examination of the tail boom assembly revealed four main rotor blade strikes in addition to the fracture that resulted in the separation of the tail boom.

Probable Cause: The pilot's ostentatious display and in-flight decision to perform an abrupt low altitude pitch up maneuver (aerobatic flight). This resulted in the main rotor blades colliding with and separating the tail boom assembly while maneuvering, and the helicopters subsequent in-flight collision with terrain.

Accident investigation:
cover
  
Investigating agency: NTSB
Report number: MIA00FA102
Status: Investigation completed
Duration: 12 months
Download report: Final report

Sources:

NTSB: https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20001212X20685&key=1

Images:





Photos: NTSB

Revision history:

Date/timeContributorUpdates
24-Oct-2008 10:30 ASN archive Added
29-Dec-2010 06:15 TB Updated [Time, Aircraft type, Operator, Other fatalities, Phase, Nature, Departure airport]
27-Feb-2013 08:19 TB Updated [Time, Aircraft type, Source]
27-Feb-2013 10:25 TB Updated [Operator]
21-Dec-2016 19:24 ASN Update Bot Updated [Time, Damage, Category, Investigating agency]
12-Dec-2017 18:30 ASN Update Bot Updated [Operator, Nature, Departure airport, Destination airport, Source, Narrative]
21-Oct-2022 19:02 Captain Adam Updated [Operator, Nature, Departure airport, Destination airport, Narrative, Accident report, Photo]
21-Oct-2022 19:02 Captain Adam Updated [Photo]
21-Oct-2022 19:03 Captain Adam Updated [Photo]
21-Oct-2022 19:03 Captain Adam Updated [Photo]

Corrections or additions? ... Edit this accident description

The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF on social media FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2024 Flight Safety Foundation

1920 Ballenger Av, 4th Fl.
Alexandria, Virginia 22314
www.FlightSafety.org