ASN Wikibase Occurrence # 44556
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Friday 18 February 2005 |
Time: | 08:11 |
Type: | Ayres S-2R-T34 Turbo Thrush |
Owner/operator: | Vance Ag |
Registration: | N4009M |
MSN: | 6012 |
Year of manufacture: | 1979 |
Total airframe hrs: | 11193 hours |
Fatalities: | Fatalities: 1 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Firebaugh, CA -
United States of America
|
Phase: | Take off |
Nature: | Agricultural |
Departure airport: | Firebaugh, CA (F34) |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The airplane impacted soft muddy terrain during a forced landing following a loss of engine power shortly after departure. The pilot departed with a full load of fertilizer and climbed above several transmission wires before the engine lost power. The airplane pitched down in a nose-low configuration and dove toward terrain. The engine's most recent inspection occurred about 2 months prior to the accident. The logbook entry for that inspection stated that the mechanic performed a hot section inspection at which time the compressor turbine (CT) disk was reinstalled with 3,595 cycles remaining. A post accident examination of the engine revealed that a CT blade had failed in fatigue initiating in the fir tree root. Near the fatigue origin, no surface damage was observed and no material anomalies were found on the fracture surface; the reason for the fatigue failure was never definitively determined. The blade was likely manufactured under a Parts Manufacturer Approval (PMA). The Safety Board Materials Laboratory reported that the chemistry of the fractured blade appeared to be consistent with the PMA specified alloy and not to the material specification the original equipment manufacturer (OEM) utilizes. A review of the Safety Board database revealed an instance of a very similar failure on an OEM manufactured CT blade. Evidence of recent marijuana use was found on toxicological evaluation, and the pilot might have been impaired ..." It is not clear whether this impairment adversely affected the pilot's actual actions during his response to the loss of engine power.
Probable Cause: the loss of engine power during takeoff climb resulting from the fatigue failure of one of the compressor turbine blades; the cause of the fatigue failure could not be definitively determined.
Sources:
NTSB:
https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20050224X00221&key=1 Location
Revision history:
Date/time | Contributor | Updates |
28-Oct-2008 00:45 |
ASN archive |
Added |
21-Dec-2016 19:24 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
06-Dec-2017 07:01 |
ASN Update Bot |
Updated [Other fatalities, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation