ASN Wikibase Occurrence # 45435
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Sunday 8 September 2002 |
Time: | 09:30 |
Type: | Adler SA-1 |
Owner/operator: | Private |
Registration: | N551SA |
MSN: | 001 |
Total airframe hrs: | 44 hours |
Fatalities: | Fatalities: 1 / Occupants: 1 |
Aircraft damage: | Destroyed |
Category: | Accident |
Location: | Mead, CO -
United States of America
|
Phase: | Manoeuvring (airshow, firefighting, ag.ops.) |
Nature: | Private |
Departure airport: | Broomfield, CO (BJC) |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:Witnesses observed "a rotor or a wing" separate from the gyroplane, and the gyroplane then descended and impacted terrain.
According to the deputy's report, a rotor blade was found about 150 feet north of the point of impact, and other debris was strewn to the southwest. The co-builder of the accident gyroplane, who was also a close friend of the pilot, contacted three gyroplane experts: the designer of the SA-1 Dominator and President of Rotor Flight Dynamics; a gyroplane aerodynamist; and the designer of another gyroplane. They examined the wreckage and compiled both a factual and analytical report. The following is based on the factual portion of the report. The separated rotor blade was bowed upward and had fractured about 2 feet from the tip. The fracture was consistent with positive overload. There was orange paint and primer transfer marks on the top and upper leading edge (the tail cone was painted orange). The attached rotor blade was also bent upward. The propeller blades exhibited no strike marks. The rotor head and hub bar were intact. The hub bar, normally bent 2.5 degrees upward, was bent approximately 10 degrees upward. The roll pillow blocks bore evidence of hammering and were mushroomed. The pitch stops were similarly damaged. In the analytical portion of the report, the necessity of maintaining blade loading at all times in order to maintain main rotor blade rotation was noted. The fracture on the separated main rotor blade was in "a purely upward bending moment which could only have occurred if the blade rpm had dramatically slowed...If totally unloaded, the blade rpm can deteriorate as fast as 120 rpm/sec." Normal rotor blade rpm is 320 to 400 rpm. If rotor blade rpm were allowed to drop, increasing the velocity of air moving through the rotor system, severe blade "flapping" would result as evidenced by the pounding and mushrooming of the roll pillow blocks and bending of the hub bar on the rotor head. A toxicological test revealed 2.024 (ug/mL, ug/g) paroxetine in the blood and liver. The drug is an antidepressant and contraindicated for flight. The pilot's personal physician prescribed the drug for the treatment of fibromyalgia, a condition manifested by muscle soreness. Adverse effects of the drug include drowsiness, muscle weakness, agitation, and tremors.
Probable Cause: the pilot's failure to maintain main rotor rpm, resulting in blade flapping, subsequent blade contact with the airframe, and loss of control.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | DEN02LA103 |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
NTSB:
https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20020920X05186&key=1 Location
Revision history:
Date/time | Contributor | Updates |
28-Oct-2008 00:45 |
ASN archive |
Added |
21-Dec-2016 19:24 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
09-Dec-2017 17:47 |
ASN Update Bot |
Updated [Destination airport, Source, Narrative, Plane category] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation